Create · Nook & Whim editorial
A hand-cut scalloped paper garland
An inexpensive seasonal project with a boutique feel.
Gather supplies
Use cardstock scraps, scissors, pencil, string and a hole punch. Select three colors and one neutral. Supervise children using sharp tools.
Make a template
Draw a half-circle about 3 inches wide with a flat upper edge. Trace it onto cardstock and cut twelve to twenty pieces. Try alternating stripes and plain paper.
Thread and arrange
Punch two holes near the flat edge of each piece. Thread them in order and adjust the spacing before tying the ends.
Hang thoughtfully
Keep paper and string away from flames, heaters, electrical fixtures and children's reach where they could pose a hazard. Store flat for next season.
Materials and measurements
Use cardstock, a ruler, scissors, a pencil, a round object for tracing, a hole punch and cotton string. Scrap paper, leftover gift wrap backed with cardstock or old craft paper can all be used. Choose paper sturdy enough to hold its shape. Adult supervision is needed for children using scissors or punches.
For an example garland along a 60-inch shelf, cut 12 pieces approximately 3 inches wide. With 1 inch between neighboring pieces, the decorated portion spans about 47 inches, leaving room for end margins. Cut a longer length of string to account for ties and any desired drape. Measure the actual hanging route before cutting.
Make a reusable template
- Trace a 3-inch-diameter circle onto scrap card.
- Draw a straight horizontal line through the center and cut one half.
- Trace the half-circle onto your selected papers.
- Cut neatly around the curved edge and set aside offcuts for smaller embellishments.
- Punch two holes near the flat edge, keeping enough cardstock around each hole to prevent tearing.
Three color recipes
| Look | Paper combination |
|---|---|
| Citrus holiday | Tangerine, cream, hot pink and deep teal |
| English garden | Botanical paper, cream and chartreuse |
| Quiet celebration | Warm white, pale pink and muted orange stripes |
Assemble and finish
Lay the pieces out on a table before threading, alternating solids and prints. Thread from the front through one hole and back through the other, so each piece sits relatively flat. Adjust the spacing, then tie the ends securely. For double-sided visibility, use patterned paper on both sides or draw on the reverse.
Make it with children
Offer older children the template to trace and cut under appropriate supervision. Younger children can choose the color order or draw designs on precut paper. Keep long strings, small offcuts and sharp implements away from very young children. Do not hang the finished garland where children can pull or become entangled in it.
Cost and storage
If you already have the basic tools and scraps, the incremental cost may be zero. Otherwise, budget for the specific paper and string you need, checking local prices before buying. Remove the garland after the celebration, unthread if necessary and store the paper pieces flat in a labeled envelope. Keep paper decorations well away from heat, candles and electrical equipment.